8844151
100 pc Air Tool Kit
V1.0
30
For technical questions call 1-800-665-8685
9. Do not store chisels below 0°C (32°F). Freezing temperatures may
cause hardened steel to become brittle. A brittle chisel may shatter
or break and cause an injury.
10. Do not cover the air vents.
11. Securely hold this tool using both hands. Using a tool with only one
hand can result in loss of control.
ASSEMBLY & INSTALLATION
INSTALL SPRING RETAINER
1. Align the rear of the spring retainer (#AH2) with the threads on the
cylinder (#AH4).
2. Thread the coil onto the cylinder. Twist the coil by the front loop. It will
spread the spring out slightly, making it easier to thread. Stop when
the rear loop is at the last thread on the left side of the air hammer.
3. To remove the spring retainer, reverse the steps above, but use the
rear loop for leverage.
ACCESSORY INSTALLATION
1. Remove the internal packing grease from the tool before the first
use. See Air Tool Lubrication for instructions.
2. Disconnect the tool from its air source and discharge any residual
air before attaching or changing chisels or accessories.
3. Select your chisel (#AH1, AH23, AH24 or AH25). Make sure it is in
good working condition and will not shatter or break while in use.
4. Push the arm of the spring retainer to widen the opening so a chisel
shank can be inserted or removed. Once the chisel is seated, release
pressure on the spring retainer so it will close over the raised ridge on
the chisel shank and lock it into place. You may need to rotate the
chisel shank a bit for it to lock.
5. Pull on the chisel to confirm it is locked into place.
6. Test the chisel placement by running the tool at no load for
approximately 30 seconds. Point the chisel in a safe direction in
case it is ejected from the air hammer.
