ProMinent Sigma/ 2 Control S2Cb, Руководство по эксплуатации

Страница: 43 / 100

The number of continuous displays depends on the iden‐
tity code, the selected operating mode and the con‐
nected additional devices, see overview "Continuous
displays" in the appendix.
A horizontal scroll bar shows the number of continuous
displays and error messages and the position of the dis‐
played continuous display or error message.
With error messages an identifier appears while displays
with clear text appear between the continuous displays
(and an error code).
The lowest line in the information displays (2nd level continuous display)
shows different information, which cannot however be adjusted here, see
overview "Secondary displays" in the appendix.
If you are in a continuous display, you can access the bottom line of the
info displays by:
1.
Keep key
[i/>]
pressed down until a small triangle appears in the
bottom line.
2. Now quickly press the
[i/>]
key to page through the info displays of
the bottom line.
8.3 Changing to set up mode
If the
[P/OK]
key is pressed for 2 seconds in a continuous display, the
pump changes to adjustment mode.
If under
„Service
è
Safety
è
Access protection“ „Lock menu“
or
„Lock
all“
was set (top left key symbol instead of "i"), proceed as follows:
1. Press the
[P/OK]
key.
ð
The
„Password“
display appears.
2. Enter the password ( [Arrow keys] !) and confirm with the [P/OK] key.
ð
The
„Password valid“
display appears.
3. Confirm the display with the
[P/OK]
key.
ð
The
„Main menu“
appears.
The following menus can be initially chosen in adjustment mode - see also
the overview "Operating/setting diagram":
n
Menu
„Mode“
n
Menu
„Settings“
n
Menu
„Service“
n
Menu „Information“
n
Menu
„Language“
To adapt the pump to your process requirements, you must:
1.
Select the operating mode in the „Mode“ menu.
2. Carry out the adjustment for this operating mode under the
„Settings“
menu.
Secondary displays
Setting
43