4
Warning
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the appliance.
WARNING:
Please don’t recharge non-rechargeable batteries.
DO NOT attempt to install or operate the unit if it has been damaged in any way.
IMPORTANT NOTICE – PLEASE READ AND UNDERSTAND THIS MANUAL BEFORE
INSTALLING YOUR PRONAUTIC P SERIES CHARGER.
This manual is written to assist in the installation of your new ProNauticP Series Charger;
however, since this is a permanent AC and DC hardwired installation, ProMariner strongly
recommends that a Certified Marine Electrical Technician® trained by the American Boat and
Yacht Council (ABYC) perform the installation. The ProNauticP Series unit you have purchased
was constructed to the safety standards of the ABYC to prevent fire and electrocution; the
installation must conform to these same industry standards. For more information on ABYC,
their Standards and Technical Information reports for Small Craft and to find a certified
technician near you, visit www.abyc.com.
CAUTION:
To preclude a safety hazard, all existing AC and DC electrical components
(e.g. wire, fuses, circuit breakers, battery switches, and connections) must be inspected
for proper condition prior to installation. Failure to confirm adequate condition and proper
installation to ABYC standard E-11 AC & DC electrical systems on board boats may result in
a dangerous condition and/or premature failure of this or other installed electrical components.
Any and all areas of the existing system that are found not in compliance with ABYC E-11
must be replaced prior to installation.
CAUTION:
If you are replacing an existing battery charger please disconnect the battery
charger output cables from the existing charger AND the battery(s). Do not use existing
cables if they are not in compliance with the sizes detailed in this manual. If you have any
doubt about your ability to fuse and wire this unit correctly PLEASE refer to www.abyc.com
for a list of certified electricians in your area that are qualified to perform this installation to
the ABYC standards.
Important Notice: FCC Class B Notification & International Standards Compliance
NOTE: This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications.
Designed, Constructed and Tested to:
UL 1236 SB, CSA C22.2-107.2, FCC Class B and CEC
EN60335-1/2-29, EN60335-2-29, EN61000-3-2, EN61000-3-3
Complies w/ ABYC A-31, AC Input Power Factor Corrected,
Meets EN61000-302:2000 + A2:2005
Safety Certified by:
To Standards:
UL 1236 SB
CSA C22.2-107.2
BC
