15
Setup and Operation
LED Status Indicator Center
Feature
LED Color
Function
AC power
blue
Auto temp control
green
with remote temp sensor connected
Active PFC
green
Volts
display system voltage
equal to the charge in the selected profile
Amps
display output amperage
based on state of charge
Charger output
percentage of charge
based on state of charge
Self test
blue
if self test was initiated
OK
green
following successful self test
Auto Maintain
green
based on state of charge
Charge
green
based on state of charge
Conditioning
green
based on state of charge
NOTE: This LED configuration indicates that the charger is functioning normally and does not
need any further attention. If the RED “Fault” LED illuminates ,or any of the “Charger Conditions”
LED’s are illuminated, consult the Troubleshooting section of this manual.
OPERATIONAL NOTE: Your ProNauticP Charger has built in safety features that can cause the unit
to shut down if it senses out of parameter operations such as over-voltage and high temperatures.
See the Troubleshooting section of this manual for more details in the event this occurs.
Optional Remote Display
Optional Remote
Power LED
blue
indicates power is ON
Fault LED
red
indicates a fault
Backlight button
toggle between ON and OFF by pushing repeatedly, default is ON
Alarm Button
toggle between silent and audible by pushing repeatedly, default is audible
toggle between silent and audible by pushing repeatedly, default is audible
Setup
Enter
selects both “scrolling mode” and activates chosen feature
(see optional remote programming section)
^
^
controls for scrolling in “scroll mode”
When the optional remote is installed, it will display the current status of the charger along
with the voltage and amperage.
1. The blue LED is illuminated when the power is ON
2. BACKLIGHT can be set to ON or OFF by toggling the BACKLIGHT button, default is ON
3. ALARM can be silenced or audible by toggling the ALARM button, default is audible
4. During the Auto Maintain (Energy Conservation Mode) only the Power, Auto Maintain and
Standby LED will be on - to view full display, including voltage and current, press any
function button
