- 12 -
NOTE:
The Prolux Self-Cleaning Vortex filter only needs to be cleaned when the entire surface of the
filter becomes dirty. Due to its highly efficient design the Self-Cleaning Vortex filter is three times more
efficient than standard filters and will have the same amount of airflow whether it’s dirty or clean. The
entire surface of the filter will have to be covered in debris before the performance of the vacuum is
affected, and the filter needs to be cleaned.
TO CLEAN AND REPLACE THE EXHAUST HEPA FILTER:
1. Open the exhaust cover by rotating it counter clockwise. (Fig 13)
2. Pull the exhaust HEPA out of the unit. (Fig 13)
3. Clean the filter using warm water, and allow air-drying completely, and then place the filter back into the unit. Or,
if the filter is too dirty, or in an unusable condition, replace the filter with a new one.
Fig 13
CLEANING THE HOUSING:
WARNING
: Always switch off the appliance and disconnect it from the outlet before cleaning it. See section "Switching
Off and Retracting Power Cord.”
ATTENTION
: Do not use Alcohol, cleaning, or scouring agents to clean your machine, as these may damage the
appliance. Clean the outside of the housing using only a slightly damp washcloth with mild soap.
