ProLights Cyber24, Руководство пользователя

Страница: 31 / 36

13
CYBER24
BRIEF OF MAIN FUNCTIONS
Reversal of the direction scene
1. Reverse the direction of all the scenes: Press the ALL REV Button, all the scenes should change their
directions.
2. Reverse the chasing direction of all the programs with speed control. Press the Chase Rev Button.
3. Reverse the chasing direction of all the programs with standard beat: Press the Beat Rev Button.
4. Reverse chasing direction of any program: Press and hold down the Rec One Button, then press down
the Flash Button corresponding to your desired program and release together.
Fade time
1. The amount of time it will take for the dimmer to go from zero output to maximum output, and vice
verse.
2. Fade time is adjusted through the Fade Time Slider, which varies from instant to 10 minutes.
Tasto tap sync
1. The Tap Sync button is used to set and synchronize the chase rate (the rate at which all scenes will se-
quence) by taping the button several times. The chase rate will synchronize to the time of the last two
taps. The led above the Step Button will flash at the new chase rate. The chase rate may be set any time
whether or not a program is running.
2. Tap Sync will override any previous setting of the speed slider control until the slider is moved again.
3. Use of Tap Sync in setting a standard beat is the same with speed control slider.
Master slider
Master Slider control provides proportional level control over all channels and scenes with the exception of
the Flash Buttons. For example: Whenever the Master slider control is at minimum all stage outputs will be
at zero except for any resulting from a Flash Button or FULL ON Button. If the Master is at 50%, all outputs
will be at only 50% of the setting of current channel or scenes except for any resulting from a Flash Button
or FULL ON Button. If the Master is at full all outputs will follow the unit setting. Master A always controls
outputs of channels. Master B controls the program or a scene except in Double Preset Mode.
Single Mode
1. All programs will run in sequential order starting in the order of program number.
2. The Segment Display will read the running program number. All programs will be controlled by the same
Speed Slider.
3. Press the MODE SELECT BUTTON and select “CHNS SCENES”.
4. Press the PARK BUTTON to select SINGLE CHASE MODE. A red led will indicate this selection.
Mix Mode
1. This mode will run all programs synchronously.
2. All programs can be controlled by the same SLIDER SPEED, or each programs speed may be controlled
individually. (See Speed Setting).
3. Press the MODE SELECT BUTTON and select “CHNS SCENES”.
4. Press the PARK BUTTON to select MIX CHASE MODE. A yellow led will indicate this selection.