ProLights Cyber24, Руководство пользователя

Страница: 25 / 36

7
CYBER24
- 3 - FUNCTIONS AND SETTINGS
BEGIN PROGRAMMING
3.1 Record enable
1. Press and hold down the Record button. While holding down the Record button, tap the Flash buttons 1,
6, 6 and 8 in sequence (several units have the 1, 5, 6 and 8 code).
2. Release the Record button, the Record led lights up, now you can begin programming your chase pat-
terns.
NOTE: The first time you turn on your unit, the default setting of the Record Code is Flash buttons 1, 6, 6 and
8. You may change the Record Code to protect your programs.
3.2 Security for your programs
To protect your programs from any editing by others, you may change the Record Code.
1. Enter current Record Code(Flash buttons 1, 6, 6 and 8).
2. Press and hold down the Record and Edit buttons at a time.
3. While holding the Record and Edit buttons, tap the desired Flash button to enter a new Record Code.The
Record Code consists of 4 Flash buttons(the same button or different buttons), be sure your new Record
Code consists of 4 Flash buttons.
4. Enter your new Record Code a second time, all channel leds and scene leds will flash three times, now
the Record Code is changed.
5. Exit Record mode. Tap the Rec Exit button while pressing and holding down the Record button, release
the two buttons at a time, the Record mode is disengaged.
IMPORTANT!
Always remember to exit Record mode when you won’t continue your programming, otherwise you may
lose control of your unit.
NOTE: The second time you enter your new Record Code different from that of the first time, the leds will
not flash, which means you’ve failed to change the Record Code. When you’ve entered a new Record Code
the first time, and now you want to cancel the new Record Code, you may press and hold down the Record
and Exit buttons at a time to exit.
3.3 Programming scenes
1. Record Enable.
2. Select the 1-24 Single mode by tapping the the Mode Select button. This will give you control of all 48
channels as you program. Be sure that Master A & B are both set at maximum. (Master A is at its maximum
in the fully up position, while Master B is at its maximum in the fully down position).
3. Create a desired scene using Channel Sliders 1-48. At 0% or DMX 0, these sliders should be at 0 position,
and at 100% or DMX 255, these sliders should be at 10 position.
4. Once the scene is satisfactory, tap the Record button to program the scene as a step into the memory.
5. Repeat step 3 and step 4 until all desired steps have been programmed into memory. You may program
up to 1000 steps into memory.
6. Select a chase bank or scene master to store your program. Tap the Page button to select a page(Page
1-4) to store your scenes.
7. Press a Flash button between 13-24 while holding down the Record button. All led will flash indicating
the scenes have been programmed into memory.
8. You can continue programming or exit. To exit Program mode, tap the Exit button while holding down
the Record button, the Record led should go out.
EXAMPLE: Program a 16 steps chase with channel 1-32 at full in sequence into Flash button 25 of Page 1.