ProLights Cyber24, Руководство пользователя

Страница: 28 / 36

CYBER24
10
- 5 - SCENES
5.1 Running scenes
1. Tap the Mode Select button to select CHNS SCENE mode indicated by the red led.
2. Tap the Page button to select the correct page the program you wish to run is located.
3. Push Master Slider B to its maximum position(fully down).
4. Move the desired Channel slider (25-48) to its maximum position to trigger the program, and the pro-
gram will fade in depending upon current fade time. You may press and hold down the relevant Flash
button (25-48) to trigger the program.
5. Move the Channel slider to adjust the output of the current program.
5.2 Running a program to Audio
1. Use built-in microphone or plug the audio source into the RCA Audio jack.
2. Select your program as described above.
3. Tap the Audio button until its led lights, indicating Audio mode is active.
4. Use the Audio Level slider to adjust the music sensitivity.
5. To return to normal mode, tap the Audio button a second time causing its led goes out, the Audio mode
is disengaged.
5.3 Running a program with the Speed slider
1. Be sure the Audio mode is disengaged, that is, the Audio led goes out.
2. Select your program as described above.
3. Move the Speed slider to the SHOW MODE position(the bottom), then tap the Flash button (13-24) while
pressing and holding down the Rec Speed button, the corresponding program will not run with the
Standard beat any longer.
4. Now you may move the Speed Slider to select your desired speed.
NOTE:The step 3 is not necessary if the selected program is not recorded with the Standard Beat.
5.4 Running a program with the standard beat
1. Be sure the Audio is disengaged. Tap the Mode Select button to select CHNS SCENE mode.
2. Tap the Park button to select Mix Chase mode, the led lights indicating this selection.
3. Select your program as described above.
4. Move the Speed slider until the Segment Display reads your desired value. You may tap the Tap Sync
button twice to define your beat time
5. While pressing and holding down the Rec Speed button, tap the Flash button(13-34) that stores the
6. program.
7. Repeat steps 4 and 5 to set a new beat time.
5.5 Change the speed mode
1. Press and hold the Record button.
2. Tap the Flash button 5 or 10 three times while holding down the Record button.
3. The 5MIN or 10MIN should light up indicating the Speed slider is set to run in the 5 or 10 minute mode.