561383-002 Issue 1.1
21
5.4 Change Duty Mode
The Change Duty mode can only be accessed with the key switch in the RCI position cycle and if manual duty selection has been
activated (This forms part of the calibration and set-up of the unit, which is not accessible during normal operation). Multiple duties
allow the machine to have more than one lifting duty. On tracked machines this may be used to allow both 360º and OVER FRONT
/
REAR lifting sectors for increased lifting capacity, or on wheeled machines it could be used for any combination of sector, support blade
and stabiliser usage. Automatic duty switching is available via the combi box, reeling drum or by sensor identification, and can be used
in conjunction with manual duty switching.
If idle, this mode will time out and return to RCI mode after 15 seconds.
Automatic duty changing will be via the following:
Reeling drum mounted on a telescopic section
Additional arm with bucket sensor attached
A.
Use the mode button to cycle through the available modes until the „change
duty‟ option is displayed. Pressing ENTER will allow adjustment of the current
lifting duty. Pressing MODE will continue the mode cycle leaving the current
setting unaltered.
If ENTER is pressed, the display shown below will appear.
B.
Use the UP & DOWN keys to select the required duty. The load chart issued
with the EA Heigh system will list all available lifting duties. There is a
maximum of 8 possible duty selections. Press ENTER to confirm the selection.
After duty changes are made, control always returns to the Rated Capacity
Indicator mode. The new duty number will appear in the lower left of the display.
Press [ENTER] to
Change DUTIES
Duty No = 1
[ADJ
◄►
] [ENTER]
