REHATEAM s.r.l.—vicolo Negrelli
5
—
31040
Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual CARBOMAX 18
SERVICE MANUAL
BACKREST HEIGHT
Aluminium or titanium backrest
m
in
. 4
c
m
A
Plastic adaptor
Remove the backrest upholstery and slide up the protecting sleeves of the backrest bands along the tube until the fixing screws are visible.
If the bolt is not accessible, remove the mudguard if it is removable or tilt the backrest backward by means of its adjustment system (see
backrest angle adjustment sheet).
Remove bolt and nut
A
and raise or lower the backrest tubes to the desired height.
If the minimum height you can reach is not enough, it is necessary to cut the lower side of the.
If the maximum height you can reach is not enough, it is necessary to change the tube.
Warning
: to guarantee a good stability, between the fixing hole and the lower side of the tube, there should be at least 4 cm. If the tube is
cut, the lower hole will be only a few millimetres front the end of the tube; therefore, you should not use that hole, the next and, sometimes
even the third to fix the backrest height.
Replace the screws and tighten.
To reduce possible play and possible noise, you can put some sticky tape around the inner tube at its bottom and at its fixing point (or just
under it).
Note: if the backrest tube is in carbon fibre, follow the instructions of the adjustment sheet “
backrest height
—
carbon fibre backrest
”.
The titanium backrest structure includes a plastic adaptor, just follow the same instructions above.
