REHATEAM s.r.l.—vicolo Negrelli
5
—
31040
Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual CARBOMAX 13
SERVICE MANUAL
BRAKE
WHEN ADJUSTING THE BRAKES, THE TURES MUST BE INFLATED TO THE CORRECT PRESSURE (except solid tyre)
The position of the brake depends on the position of the rear wheel.
Loosen the headless bolt
A
located in the lower side of the support
B
.
Position the brake-knurled rod
P
at a distance
D
of a few millimetres and parallel to the
ground.
Temporarily tighten the headless bolt
A
and try the brake out to check if the adjustment is
good.
If necessary, repeat the same operation to reach the good adjustment.
A good adjustment has the brake not too hard to engage but braking, so you will have to
find the suitable compromise.
Once reached the correct position, tighten the headless bolt
A
.
Carry out the same operation on the other side.
The adjustment for the sport brake is the same except for the distance
D
, in fact, the brake,
in its resting position is far away from the tyre. Just make a few tries
Note
: if the frame s rather short (short seat depth) there may be interference with the front
curve of the frame. In that case, it is necessary to move the rear wheel backward (point of
balance) as much as necessary (see adjustment sheet ”setting”)
A
B
A
B
In order to have a stable fixing of
the brake, it is possible there is a
small block that is located within
the opening of brake tube.
The clamp must always tighten
such small.
X
