ProFlow Water softener, Инструкция по установке и эксплуатации, Страница: 16 / 104

ELECTRONIC CONTROL PANEL
EN - English
Page 16
DUPLEX/TRIPLEX ECO PARALLEL :

Each Simplex system must be programmed individually;
the program does NOT necessarily have to be the same on
all Simplex systems, that make up a Duplex/Triplex system!
1. Press the scroll  button and hold it for 5 sec until the
display shows:
2.
Within 10 sec, press the up  button; the display will
show:

Press the up

or down

button to set the
hardness unit . Make sure to also adjust/convert the
exchange capacity!
3.
Press the scroll

button again; the display will show:

Press the up  or down  button to set the
exchange capacity per litre of resin .
4.
Press the scroll  button again; the display will show:

Press the up

or down

button to set the volume
of resin .
5.
Press the scroll  button again; the display will show:

Press the up  or down  button to set the number
of days between regenerations .
6.
Press the scroll  button again; the display will show:

Press the up  or down  button to set the length
of the regeneration cycle .

Press the scroll

button again to advance to the
next regeneration cycle.
Cycle 1 Backwash
Cycle 2 Brine draw/slow rinse
Cycle 3 Fast rinse/refill
7.
Press the scroll

button again; the display will show:

Press the up  or down  button to set the type of
water meter sensor .
8. Press the scroll  button again; the display will show:

Press the up  or down  button to set the
regeneration mode :

Immediate : when the remaining capacity equals
0, an immediate regeneration is started.

Dlyd/Immd : when the remaining capacity equals
the reserve capacity, a delayed regeneration at
the programmed time of regeneration is started;
however when the remaining capacity equals 0
before the programmed time of regeneration is
reached, an
immediate regeneration is started.

Delayed : when the remaining capacity equals
the reserve capacity, a delayed regeneration at
the programmed time of regeneration is started.
9. Press the scroll  button again; the display will show
(only when the regeneration mode is set to 'Delayed' or
'Dlyd/Immd'):

Press the up

or down

button to set the time of
regeneration .
10. Press the scroll  button again; the display will show
(only when the regeneration mode is set to 'Delayed' or
'Dlyd/Immd'):

Press the up  or down  button to set the reserve
capacity :

Variable : the reserve capacity is calculated
automatically, based on the registered daily
water usage.

Fxd : press the scroll  button again and press
the up  or down  button to set the reserve
capacity to a fixed amount .
11.
Press the scroll

button again; the display will show:

Press the up  or down  button to save the
program into the NOVRAM® and exit the
programming level.
12.
Repeat steps 1-11 for all Simplex systems.
Cycle 1: XX min
System Check
HardUnit: °f
Resin: XXX liters
ExCap: 5.5 °f M3/L
Override: 7 days
MTR: SNAP SENSOR
Regen:Immediate
Rsrv Variable
Regen @ 2:00
Exit