17.
Start the engine of the donor vehicle (donor vehicle with the good battery).
18.
Turn the ignition key of the receiving vehicle (receiving vehicle with the low/weak battery)
to the ACCESSORY or NEUTRAL position.
BE CAREFUL NOT
TO START THE
ENGINE.
19.
Connect the power plug to the donor vehicle
FIRST
.
20.
THEN
plug the receiver power plug into the vehicle to be started.
21.
Leave the
ON/OFF button
(I/O) in the "O" position, it shows the battery capacity of the
receiver vehicle in %. The battery must be recharged immediately when it displays "LO".
If the display does not show a number, the battery of the receiving vehicle is defined as
empty, it cannot be recharged. Please call the technician for a new battery change. If
display shows "FL", it means full charge.
22.
Press the
ON/OFF
button into the "I" position, the display shows the increasing charge
level. Charge until displays shows at least or over 20%, which is the minimum level to
start.
23.
Press the
ON/OFF button
to the "O" position again, if the display shows over 20%, it
means that the battery is ready to start.
NOTE
: The charging time depends on the condition of the battery in the receiving vehicle.
Typical charging time is approximately 15 minutes, but no more than 45 minutes. The car-
to-car charger will not work on vehicles with damaged electrical systems.
24.
Unplug both power plugs and then start your weak vehicle
.
WARNING
: Before starting the car, the plugs must be disconnected. If the car engine does
not start after the second attempt, contact a professional car service.
25.
Allow the car's starting engine to run for further 30 minutes to keep the battery charged.
26.
Pack and store the unit.
Correct order to connect the vehicles
Put the d
onor Power Plug into a strong car
Put the recipient power plug into a
problem car
