PROCONCEPT PLG029, Руководство оператора, Страница: 13 / 44

v.080131
13
EN
G
LIS
H
OPEraTING INSTrUCTIONS
3. Move the choke lever (L, fig.19) up to choke or cold start: .
NOTE:
This is not required if the engine is already warm.
4. Pull the recoil start handle 2 or 3 times quickly until engine attempts to run.
5. Move the choke lever down to the run or warm start position: .
6. Pull the starter grip until engine runs.
7. Allow engine to run at idle for about 10 seconds to warm up.
8. To speed up the motor so it engages the clutch and turns the cutter, press and
hold the throttle interlock button (H, fig.1 & 17) while squeezing the throttle
trigger (O, fig.1 & 17).
IMPORTANT: The blade should not turn when the motor is running at idle. If it
does, even a little, see Maintenance, p.17.
NOTE:
It is normal for smoke to be emitted from a new engine after first use.
To Stop the Engine
Move the ignition switch (G, fig.17) to “
STOP
”: the STOP position.
running the Engine
After 2 hours, stop and check that all nuts and screws remain securely fastened.
Tighten if necessary.
During the first 10 hours of work, run the engine only at a moderate speed.
Do not run the engine at high speed during this period so that the different
components can wear in gradually and without damage.
At the end of the break-in period, the motor will be able to achieve maximum
power.
Prolonged cutting at partial throttle will result in oil dripping from the muffler.
Operating Position
WARNING:
Always position the unit on the operator’s right side. Using the unit on
the operator’s left side will expose the user to hot surfaces and can result in a
possible burn injury.
WARNING:
To avoid burns from hot surfaces, never operate unit with the bottom of
the engine above waist level.
1. Hold the trimmer with the right hand on the rear control handle and the left hand
on the auxiliary “J” barrier handle. Keep a firm grip with both hands while in
operation.
2. Hang the trimmer from the shoulder by the strap, Adjust the shoulder harness to
position the brush cutter at a comfortable operating position and to assure that
the shoulder harness will reduce the risk of operator contact with the blade and
with the control handle about hip height.
3. Maintain your grip and balance on both feet.
4. Position yourself so that you will not be drawn off balance by the blade thrust or
kickback reaction of the cutting blade.
5. Cut from right to left.
Blade Thrust
Exercise extreme caution when using the brush cutter blade with this unit. Blade
thrust is the reaction that may occur when the spinning blade contacts anything it
n
n
n
n
n