PROCONCEPT PLG029, Руководство оператора

Страница: 11 / 44

v.080131
11
EN
G
LIS
H
aSSEMBLy
7. Align the hole in the blade seat flange with the hole in the gear head.
8. (fig.16) Insert the T25 torx driver wrench as a gear head locking tool through the
slot in the blade seat flange and gear head.
9. Thread on the line trimmer head. It is left-threaded and screws on
counterclockwise.
10. Tighten the line trimmer head well.
11. Check that the line cutting blade (V, fig.16)does not have its shipping cover over
it.
WARNING! Do not install the line trimmer head without first attaching the safety
guard extension for line trimmer
WARNING! The line cutting blade on the guard is sharp. Avoid contact with the
blade. Failure to avoid contact can result in serious personal injury.
NOTE:
Store the remaining brush cutter parts; the blade, blade retainer flange, nut,
and cotter pin together for later use.
OPEraTING INSTrUCTIONS
fUEL
IMPORTANT: Never use straight gasoline in your unit. This will cause permanent
engine damage and void the manufacture’s warranty for that product. Use
regular grade unleaded gasoline mixed with 2-cycle engine oil in 40:1 ratio for
best results. Never use a fuel mixture that has been stored for over 60 days.
GASOLINE - The lowest recommended octane rating is 87. If you run the engine
on gasoline with a lower octane rating than 87 so-called “knocking” can occur.
This leads to an increased engine temperature which can result in serious engine
breakdown.
TWO-STROKE OIL
-
You must use premium grade 100% synthetic oil intended for
heavily stressed two-stroke engines mixed at a 40:1 ratio, intended for air cooled
engines. Do not use any 2-cycle oil product with a recommended mixing ratio of
100:1. If needed, contact your dealer when selecting oil.
REMEMBER: Mixing ratio: 40:1
IMPORTANT:
Never use two-stroke oil intended for water cooled outboard engines
or four-stroke engines.
MIXING FUEL
WARNING: Fuel is VERY flammable. Use extreme caution when mixing, storing or
handling fuel or serious personal injury could result.
WARNING:
Always mix and store the fuel in a properly marked container that is
approved by local codes and ordinances for such usage. Do not mix fuel in an
enclosed room or near open flames. Assure adequate ventilation.