Adjustments
HVZ-uni
V7
18/06/12
19 / 36
6.2.3
Gripper length main gripping direction
Setting of the steel-lamellas
●
The steel-lamellas should not stitch out sideways over
the contur of the laying cluster, because they could hit
the already laid blocks when laying a new cluster into
an edge.
●
Depending on the length of a pack, the lamellas which
are stitching over, should be replaced by the 1.5 lamella
or the half lamella.
●
When mounting the screws with the lamellas, pay
attention to the configuration of the spring washers as
shown on the drawing. Tighten the self-locking nuts
tight and then loosen them again by 1/2 turn.
●
In order to give the steel-lamellas a higher flexibility
and therefore a good, secure and gentle grip to the
pavers.
Recommendation
●
If later on, when doing constant laying work, single
pavers are falling out of the gripped cluster in always
the same position: Get more gripping force into that
row where the block always drops out by completely
tighten the screws. Doing this, the gripping force in this
row is getting higher than in the other rows.
●
For special paver shapes it can be advantageous or
even necessary (for example on hexagen blocks) to use
special lamellas. Contact the supplier of the laying
clamp, giving him information about the laying cluster
which has to be installed.
