Adjustments
HVZ-uni
V7
18/06/12
21 / 36
Setting of the steel-lamellas L
●
The steel-lamellas should not stitch out sideways over
the contur of the laying cluster, because they could hit
the already laid blocks when laying a new cluster into
an edge.
●
Depending on the length of a pack, the lamellas which
are stitching over, should be replaced by the 1.5 lamella
or the half lamella.
●
When mounting the screws with the lamellas, pay
attention to the configuration of the spring washers as
shown on the drawing. Tighten the self-locking nuts
tight and then loosen them again by 1/2 turn.
●
In order to give the steel-lamellas a higher flexibility
and therefore a good, secure and gentle grip to the
pavers.
6.2.4
Adjustment side gripping direction
Gripper length side gripping direction R
●
Check the measurement of the depth of the laying
cluster.
●
Included in the delivery there are two C-profiles
(standard length 850 mm)
●
Shorten them to about 50 mm less than the depth of
the laying cluster by cutting them or ordering them with
the supplier.
●
If the C-profiles have to be shortened, shorten them by
the same amount on both sides in order to have the
holes in the C-profiles still in the centre of the profiles.
●
Fix the side gripper holder as shown. Do not tighten the
screws completely.
●
The position of the C-profiles on the side gripper holder
has to be done exactly, as described in 5.3, only tighten
the screws completely afterwards.
