7
PROBRITE.COM
Please call 1-844-507-5651 or email [email protected] for further assistance.
6
Visit
www.probrite.com/install
for installation video tutorials and product support
☐
If necessary, strip 3/8" of insulation
from junction box or fixture (A) wires
(fig 1).
☐
Connect
fixture black wire to house
black wire
, the (+) line, and
fixture
white wire to house white wire
, the (-)
common by twisting the exposed wires
together and using the wire nuts (BB).
Ensure no loose wires.
Installation (continued)
3
Remove the
mounting plate
C
DD
D
NOTE:
The mounting plate (D) comes pre-as-
sembled on the light fixture (A) for shipping.
NOTE:
The mounting plate tightening bolt (C)
comes pre-installed on the light fixture.
☐
Remove the mounting plate (D) from
the back of the fixture by loosening
the mounting plate tightening bolt (C)
using the allen key (DD).
4
Installing the
mounting plate
☐
Route the junction box wires through
the large center hole in the mounting
plate (D).
☐
Align the holes on the mounting brack-
et (D) with the holes on your junction
box. Use two (2) or four (4) depending
on the number of screw holes available
on the junction box to attach mounting
bracket.
☐
For wall mount
, the "TOP" arrow must
point upward.
☐
For eave mount
, the "TOP" arrow must
point toward the building.
Installation (continued)
5
Hang fixture to
mounting plate
☐
For hands free mounting, place the hook
into the slot of the junction box plate (D)
to support the fixture while connecting the
wires.
6
Making the electrical
connections
TIP:
Ensure the light fixture (A) can safely
hang onto the mounting plate (D) to allow for
use of two hands to make the wiring (fig 2).
connections.
A
D
E
A
E
D
BB
(fig 1).
(fig 2).
TIP:
Only unscrew the tightening bolt (C) far
enough to remove the mounting plate (D). Do
not fully remove the tightening bolt (C).
TIP:
Use the leveling bubble (B) on the
mounting plate (D) to ensure a level install.
E
D
A
(fig 1).
TIP:
Hold stripped ends near each other and align any
frayed strands (do not twist wires).
Push the wires into wire nut (BB) and use your fingers
to twist the wire nut clockwise until tight. Check for
tightness by pulling wires.
LIGHTING
FIXTURE
(+) LINE
(-) COMMON
BLACK
WHITE
AA
D
B
