Proactive NJ1 e-assistant, Руководство по сборке

Страница: 6 / 40

Usage instructions Adapter & Adaptation
5
Figure 5: Adaptation elements on the adapter
The horizontal adjustment option of 105 mm in
seven 15 mm steps and the potential angle
adjustment of the locking plate as well as the
infinite horizontal adjustment of the centring
column mount enables the position of the
adapter to be modified on the wheelchair and
adjusts the adapter to the geometry of the
wheelchair. Adapt the adapter to the wheel-
chair as described in Chapter 4.3 and check
the necessary adjustment work.
To position the locking plate horizontally ,
the M8 fixing screw (Metric size 6 mm) must be
released and tightened again in the right
thread hole in the fixing rail at 17 Nm and pro-
tected with locking fluid.
Figure 6: Positioning the locking plate in 15 mm
steps
Figure 7: M8 fixing screw to horizontally position the
locking plate
To adjust the angle of the locking plate , the
four M4 adjustment screws (Metric size 2 mm)
must first be released. The four M6 fixing
screws are then loosened (Metric size 5 mm
and 4 mm). The locking plate can now be
moved into the correct angle. When the angle
adjustment is completed, the four fixing screws
can then be tightened with 7 Nm and the four
adjustment screws with 2 Nm. Secure the ad-
justment screws with locking fluid.
Figure 8: M6 fixing screws and M4 adjustment
screws to adjust the angle of the locking plate
To position the centring column mount
horizontally , loosen the two M6 fixing screws
(Metric size 5 mm). You can now infinitely ad-
just the centring column mount along the
adapter tube. At the desired position, tighten
the fixing screws again with 7 Nm and secure
these with screw locking fluid.
Centring column mount
Locking plate
Fixing rail with thread
holes
M6 fixing screws
M4 adjustment screws
M8 fixing screw