Proactive NJ1 e-assistant, Руководство по сборке

Страница: 32 / 40

Usage instructions Adapter & Adaptation
31
Steering head position on the adapter
The steering head can be mounted in two positions: high and low. To change the position of the steer-
ing head, the entire steering head, coloured yellow, is attached to the adapter, rotated by 180°. To do
so, you need to loosen the four M6 threaded pins (Metric size 3 mm), orange coloured, and the two
M6 clamp screws (Metric size 5 mm), green coloured, with washers and corresponding nuts (Metric
size 17 mm). In addition, two M6 fixing screws are to be positioned centrally between the M6 clamp
screws (Metric size 4 mm) (one right and one left), in a threaded shaft (10 x 48.5), blue coloured. One
of these fixing screws and the shaft must also be removed. While one of the fixing screws is being
removed, the other fixing screw must be held.
The steering head can then be removed from the adapter and reinserted rotated. If the angle of the
steering head is adjusted correctly (chapter 6.4), the two clamp screws (green) with washers and cor-
responding nuts as well as the fixing screw (blue) with shaft must be tightened again, with a tightening
torque of 7 Nm and secured with screw locking fluid. Then, the M6 threaded pins (orange) must be
turned again towards the steering head connection so that they rest on the steering head connection.
Finally, the frame clamps and the lifting eye must be correctly repositioned.