![background image](http://html1.mh-extra.com/html/pro-point/8619470/8619470_operating-manual_1607430014.webp)
14
(7) Place wire onto spool holder - (spool retaining nut is left hand thread )
Feed the wire through the inlet guide tube on to the drive roller.
(8) Feed wire over the drive roller into the outlet guide tube, Push the wire through approx 3-4in
(9) Align the wire into the groove of the drive roller and close down the top roller making sure the wire is in
the groove of the bottom drive roller, lock the pressure arm into place.
(10) Apply a medium amount of pressure to the drive roller.
(11) Remove the gas nozzle and contact tip from the torch neck,
(12) Press and hold the inch button to feed the wire through to the torch neck, release the inch button when
the wire exits the torch neck.
(13) Fit the correct sized contact tip and feed the wire through it,
screw the contact tip into the tip holder of the torch head and nip it up tightly.
(14) Fit the gas nozzle to the torch head.
(15) Carefully open the gas cylinder valve and set the flow rate to between 11-21cfh.
(16) Set the welding parameters using the wire feed and voltage control knobs.
(17) Or use Smartset, Smartset is a predefined setting based on Gas and wire used.
The machine will preselect Voltage and wire speed allowing the user to quickly find the best welding pa-
rameters for a given metal.
(12) Press and hold the inch wire button to
feed the wire down the torch cable through
to the torch head.
(11) Remove the gas nozzle and contact tip
from the front end of the mig torch.
(13) Fit the correct size contact tip over
the wire and fasten tightly into the tip
holder.
(14) Fit the gas nozzle to the torch head.
(16) Set welding parameters using the
voltage and wire feed controls.
(17) Smartset is a predefined setting based
on Gas and wire used. The machine will
preselect Voltage and wire speed allowing
the user to quickly find the best welding
parameters for a given metal.
(9) Close down the top roller bracket and clip
the pressure arm into place.
(10) Apply a medium amount of
pressure to the drive roller
(15) Carefully open the valve of the gas
cylinder, set the flow to 21cfh
Installation & Operation for MIG with Gas for
Pro.Point 145 & 180
Содержание 8619470
Страница 48: ...48 NOTES ...
Страница 49: ...49 NOTES ...
Страница 50: ...50 PRINCESS AUTO LTD Phone 1 800 665 8685 WWW PRINCESSAUTO COM MADE IN CHINA ...