6
7. Attach the Handlebar (47) to the Upright (3) with the
Upright Clamp (45) and the Adjustment Handle (46).
Note: The Adjustment Handle may work like a span-
ner. Turn the handle clockwise, push it toward the
Handlebar, turn it counterclockwise, pull it away from
the Handlebar, and then turn it clockwise again.
6. While another person holds the Console (6) near the
Upright (3), connect the console wire harness to the
Upper Wire Harness (32).
Insert the excess Upper Wire Harness (32) downward
into the Upright (3). Attach the Console (6) to the
Upright with four M4 x 15mm Screws (40). Be careful
to avoid pinching the wires.
3
40
32
6
Console Wire
Harness
40
6
47
3
45
46
7
5. The Console (6) requires four “AA” batteries; alkaline
batteries are recommended. Press the tab on the bat-
tery cover and remove the battery cover. Insert four
batteries into the console; make sure that the batter-
ies are oriented as shown by the diagram inside
the battery compartment. Then, reattach the battery
cover.
Note: The Console (6) can be operated with an option-
al power supply instead of batteries. To purchase a
power supply, call the telephone number on the
front cover of this manual. Plug one end of the
power supply into the jack on the console. Plug the
other end of the power supply into an appropriate out-
let that is properly installed in accordance with all local
codes and ordinances.
6
Batteries
Battery
Cover
5
Be careful to avoid
pinching the wires
