6
11
50
27
6. Identify the Left Handlebar (6), which is marked with a
sticker. Insert the Left Handlebar into one of the
Handlebar Arms (5); make sure that the Handlebar
Arm is turned so the hexagonal holes are on the
indicated side. Attach the Left Handlebar to the
Handlebar Arm with two M6 x 38mm Button Bolts (50)
and two M6 Nylon Locknuts (27). Make sure that the
Nylon Locknuts are inside of the hexagonal holes.
Do not fully tighten the Button Bolts yet.
Apply a small amount of the included grease to the left
axle on the Upright (2).
Make sure that there are two Small Handlebar
Bushings (49) in the Left Handlebar (6). Slide a
Handlebar Spacer (47) and the Left Handlebar onto the
left axle on the Upright (2) as shown. Make sure that the
Handlebar Spacer is turned so the curved side is fac-
ing the Upright. Tap an Axle Cap (14) onto the axle.
Repeat this step to assemble the Right Handlebar (8)
and the other Handlebar Arm (5).
Grease
6
47
14
49
5
2
5
6
8
Hexagonal
Holes
5
1
2
68
68
Make sure that
the wires do
not get pinched
and damaged
during this
step.
44
53
68
59
59
59
5. Whilst another person holds the Upright (2) near the
Frame (1), connect the Upper Wire (44) to the Sensor
Wire (53).
Push the excess wire down into the Frame (1). Slide
the Upright (2) onto the Frame. Be careful to avoid
pinching the wires. Attach the Upright with four M8 x
19mm Button Screws (68) and four M8 Split Washers
(59). Do not tighten the Button Screws yet.
Turn on the fan if desired.
To turn on the
fan at low
speed, press
the fan button.
To turn on the
fan at high
speed, press
the fan button a
second time. To
turn off the fan, press the fan button a third time.
Note: If the fan is turned on and the pedals are
not moved for about half a minute, the fan will
turn off to conserve the batteries.
Rotate the thumb wheel on the right side of the
console to pivot the fan to the desired angle.
When you are finished exercising, the console
will automatically turn off.
If the pedals are not moved for a few seconds,
the displays will pause and the time will flash in
the large display.
If the pedals are not moved and the console but-
tons are not pressed for a few minutes, the con-
sole will turn off to conserve the batteries.
6
5
Thumb
Wheel
Fan
Button
