12
5
Inspect and tighten all parts of the elliptical exerciser
regularly. Replace any worn parts immediately.
To clean the elliptical exerciser, use a damp cloth and
a small amount of mild soap. Important: Keep liq-
uids away from the console, place only a sealed
water bottle in the water bottle holder, and keep
the console out of direct sunlight. During storage,
remove the batteries from the console.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. To replace the batteries, see
assembly step 3 on page 5.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, you must remove the Left Pedal Arm (11) and
the Left Side Shield (3).
Remove the Pedal Arm Bolt Set (40), the M10 x
25mm Patch Screw (22), the M10 Washer (35), and
the Wave Washer (9) from the Left Pedal Arm (11).
Remove the Left Pedal Arm. Next, remove the two M4
x 25mm Screws (56) and the four M4 x 16mm Screws
(42) from the Left Side Shield (3).
See the drawing below and locate the Reed Switch
(53). Loosen, but do not remove, the indicated M4 x
16mm Screw (42). Slide the Reed Switch slightly
toward or away from the Magnet (58) on the flywheel,
and then retighten the Screw. Turn the left Pedal Disc
(15) for a moment. Repeat until the console displays
correct feedback. When the Reed Switch is correctly
adjusted, reattach the Left Side Shield (3) and the Left
Pedal Arm (11).
HOW TO ADJUST THE DRIVE BELT
If the pedals slip whilst you are pedaling, even when
the resistance is adjusted to the highest setting, the
Drive Belt (19) may need to be adjusted. To adjust the
Drive Belt, you must first remove the left side shield.
See HOW TO ADJUST THE REED SWITCH at the
left and remove the left side shield.
Next, loosen the
M8 x 22mm Flat
Head Screw
(41) and turn
the M10 x
60mm Button
Bolt (62) until
the Drive Belt
(19) is tight.
When the Drive
Belt is tight,
retighten the
Flat Head
Screw. Then, reattach the left side shield.
MAINTENANCE AND TROUBLESHOOTING
42
56
42
42
22
35
3
40
15
41
62
19
9
11
58
53
42
2. Whilst another person lifts the back of the Frame (1),
attach the Rear Stabiliser (28) to the Frame with two
M8 x 53mm Button Bolts (34), two M8 Washers (48),
and two M8 Nylon Locknuts (38).
34
28
48
48
1
2
38
3. The Console (23) requires four 1.5V “D” batteries;
alkaline batteries are recommended. Remove the
screw from the battery drawer, pull the battery drawer
open, and insert four batteries. Make sure that the
batteries are oriented as shown by the markings
inside the battery drawer. Close the battery drawer
and reattach the screw.
4. Have another person hold the Console (23) in the
position shown. Connect the console wire to the Upper
Wire (44). Next, insert the excess wire down into the
Upright (2).
Attach the Console (23) to the Upright (2) with four M4
x 20mm Screws (43). Be careful to avoid pinching
the wires.
3
23
23
4
Batteries
Screw
43
2
Console Wire
44
