Pro-face PL-6930-T41, Руководство пользователя

Страница: 115 / 175

PL-6930 / PL-7930 Series User Manual
6-2
6.1 Setting Up Your PL Unit
There are two types of PL units. One has a hard disk with no pre-installed OS and the other has a hard disk
with a pre-installed OS. Therefore, the setup procedures used will differ.
6.1.1 Setting Up an HDD with no Pre-installed OS
First, when you use a hard disk with no pre-installed OS, you will need to install either Windows
®
2000 or
Windows
®
XP. You also need to install any required utility software.
„
Installing the HDD Unit
Check to see if a hard disk unit is installed in your PL unit. If it is not, install the “PL-HD240” (the HDD unit
with no pre-installed OS) prior to going to the next step. For the installation method, refer to the Installation
Guide that comes with the HDD unit with no pre-installed OS.
„
Setting Up HDD Unit System Information
Check to see if a hard disk unit is installed in your PL unit. If it is not, install the HDD unit with no pre-
installed OS. After that, you will need to set up a variety of system information. Set up this information so that
the system recognizes the newly-installed hard disk drive. For detailed setup procedures about the hard disk,
refer to the Installation Guide that comes with the HDD unit with no pre-installed OS.
„
Setting Up the OS
Install your operating system. For the setup procedures about the OS, refer to that product's installation man-
ual.
„
Setting Up the PL Dedicated Software
(1) Download the necessary drivers and utility software from the Pro-face support site “Otasuke Pro!”
(2) Decompress the downloaded data, then the [Proface] folder has been created in drive C.
• Specify [Disabled] for the USB-Device29 and the Function7 of the BIOS when
you install commercial Windows
®
, using a USB CD-ROM drive.
• The PL unit supports Windows
®
2000 Service Pack 4 and Windows
®
XP Service
Pack 2. The PL unit performance cannot be guaranteed when any other
operating system is used.
SEE URL http://www.pro-face.com/otasuke/
• A USB keyboard is required to set up the PL.
SEE
‹
Integrated Device Control Sub-Menu (page5-26)