Pro-face FP5000 Series, Руководство пользователя, Страница: 62 / 95

Installation and Wiring
62
Connecting the DC Power Cord
NOTE:

The SG (signal ground) and FG (functional ground) terminals are connected internally in this
product.

When the FG terminal is connected, be sure the wire is grounded. Not grounding this product
can result in excessive electromagentic interference (EMI).
DC Power Cord Preparation

Make sure the ground wire is either the same or heavier gauge than the power wires.

Do not use aluminum wires in the power supply cord.

To prevent the possibility of a terminal short, use a pin terminal that has an insulating sleeve.

If the ends of the individual wires are not twisted correctly, the wires may create a short circuit.

The conductor type is solid or stranded wire.

Use copper wire rated for 75

C (167

F) or higher.
*1 For UL compatibility, use AWG14 or AWG13.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH

Remove all power from the device before removing any covers or elements of the system, and
prior to installing or removing any accessories, hardware, or cables.

Remove power before wiring this product’s power terminals.

Always use a properly rated voltage sensing device to confirm power is off.

Replace and secure all covers or elements of the system before applying power to this
product.

This product uses only 12...24 Vdc power. Using any other level of power can damage both
the power supply and this product.

Since this product is not equipped with a power switch, be sure to connect a power switch to
the power supply.

Be sure to ground this product’s FG terminal.
Failure to follow these instructions will result in death or serious injury.
Power cord diameter
0.75...2.5 mm
2
18...13 AWG
*1
Conductor type Solid or stranded wire
Conductor length
Recommended driver
*2
SZS 0.6 x 3.5 (1205053)
Recommended pin terminals
*2 3201288 AI 0,75 - 10 GY
3200182 AI 1 - 10 RD
3200195 AI 1,5 - 10 BK
3202533 AI 2,5 - 10 BU
Recommended pin terminal crimp
tool
*2
CRIMPFOX 6