Printronix L1024, Руководство по обслуживанию

Страница: 359 / 372

C–37 Appendix C – Continuous Form Stacker
5. Feed the cable through the opening formed by the front paper guide and the front paddle
drive pivot bracket and re-attach it to the center post of the paper tray.
6. Rewind the cable onto the support shaft, allowing for clearance of the screw holding the
support disc to the moveable core. Continue rewinding until the ball slides reach the top of
the electrical housing.
NOTE: Make sure the side guide wings are raised to the horizontal position.
7. Adjust the height of the paper tray so there is approximately two inches between the top of
the front paddle drive idler pulley assembly and the center post of the paper tray (see
Figure C–24).
2”
Figure C–24. Adjustment of Paper Table Height
8. Re-attach the spring assembly clip to one of the upper holes on the support disc. Adjust as
necessary to maintain the proper spacing between the paper tray and the paddle drive idler
assembly (see Figure C–23 and Figure C–24).
NOTE: Center the tray support cable between the front paper guide and the
paddle drive mounting bracket.