Printronix L1024, Руководство по обслуживанию

Страница: 299 / 372

13–27 Chapter 13 – Troubleshooting Guide
Service Call Error Messages
A fatal error is any error that cannot be corrected by operator actions alone. The errors listed in the table
that follows are all potentially fatal errors. However, except for one error, you might be able to clear them
by resetting the printer engine. That one exception is the error “33 REPLACE EEPRM,” which is fatal and
cannot be cleared by resetting the printer engine.
NOTE: Before performing any corrective actions, reset the printer engine, as
described below. If a given error continues to appear on the LCD after you
reset the printer engine, then cycle the power to the printer. If the error
persists, it means that the printer requires further service.
Resetting the Printer Engine
To reset the printer engine, press the Up and Next keys on the control panel simultaneously.
Table 13–3. Service Call Error Messages
Message Explanation Corrective Action
15 FUSER FAIL
Call Service A rotation error of the
pressure roller cam has
occurred. There is an unfused
image at the fuser. See page 13–36.
16 FUSER FAIL
Call Service The pressure roller cam did
not stop, or is out of position
after a stop attempt, or the
sensor is defective. See page 13–36.
17 FUSER FAIL
Call Service The pressure roller cam did
not start, or the sensor is
defective. See page 13–36.
18 FUSER FAIL
Call Service The sensor that detects the
position of the Speed Control
Paper Guide is defective. See page 13–37.
23 THRMISTR FAIL
Call Service One of the thermistor leads or
associated wires is broken, or
the thermistor is open. See page 13–37.
24 THRMISTR FAIL
Call Service The thermistor leads or
associated wires are shorted
together, or the thermistor is
shorted, or the printer
temperature is extraordinarily
high. See page 13–38.
25 ENCODER FAIL
Call Service The tractor encoder signal is
faulty. See page 13–32.
(Continued on next page)