Printronix L1024, Руководство по обслуживанию

Страница: 122 / 372

7–26 Chapter 7 – Fuser Subsystem
Clutch cable positioned
toward front of printer
Front of printer
Detail 7–4. Fuser Stepper Motor Clutch Positioning
16. Only if necessary, remove the right side Fuser Roller Locking Lever from the Fuser Base
Frame. If the Locking Lever must be removed, do not reuse it. Replace it with a new Locking
Lever.
17. Remove the Fuser Transfer Gear from the Fuser Base Frame.
18. Remove 1 E-ring, then remove the Rear Inner Transfer Gear.
19. Remove 1 E-ring, then remove the Exit Guide Drive Gear.
20. Remove 1 E-ring from the Shaft for the Fuser Clutch, then remove the Fuser Clutch from the
Shaft.
NOTE: Do
not disassemble the Fuser Clutch. Keep all Fuser Clutch parts together
as one Assembly. Do not remove the cable from the Clutch Assembly
unless absolutely necessary.
21. The Front Inner Transfer Gear can be removed after the Clutch Assembly has been removed.
22. Remove the Spring from the center of the Speed Control Paper Guide, then remove 1 Screw
from each end of the Guide and remove it from the Fuser Base.
23. With the Fuser Clutch removed, slide the right Fuser Cam Ball Bearing off of the Shaft.