Printed in USA 4/06 © 2006
16
625-525revG-EN
Steamer
625-OS
Water Tube Replacement
Stores that have harder water in their areas may experience scale buildup in their water tubes, thus clogging the tube
and preventing water from being dispensed into the steaming chamber. If the tube needs to be replaced, this sheet will
illustrate how to replace the water tube.
First, turn off and unplug steamer. Let steamer cool
down. To remove the rear cover plate that shields
the water tube, use a Phillips head screw driver to
remove the two
screws. Next, take
off the rear cover
plate to access the
water tube.
1
To pull the tube out from the water valve, push in
the grey disk
on the water
valve and then
slowly slide the
tube from the
water valve.
Grey disk is here —
at end of valve
2
Using pliers, gently pull the tube out from the platen.
You may need to softly
rock it back and forth.
Replace the black
insulating bushing if the
original bushing pulled out
with the water tube. All
units must have a bushing
installed. To reinstall the
bushing, lubricate it with
water and push it back
into the opening.
Platen must be cool.
CAUTION
3
To insert the new tube, first insert the top end
through the hole that leads to the platen. The tube
will fit through the insulating bushing.
4
Push the other end of the tube into the water valve.
Ensure that you feel it click into place. Gently tug on
the water tube to check if it is secure. If the tube
slides out, reinstall the tube. If tube is improperly
installed, water will
leak at this point.
5
Finally, reinstall the rear cover plate. Turn on unit
and begin a water cycle to check for leaking at the
water valve. If leaking occurs at the back panel of
the steamer, turn off unit and repeat Step 5.
6
