If you have questions or issues please contact 1-866-429-7566 for expert assistance.
_______________________________________________________________________________________
Please visit
www.PrimoWater.com
for more useful information, instructional videos, tips and special offers.
Page |
9
Activate Cooling
Notice: This unit will not dispense cold water until the green switch is in the ON
position.
To activate, push top side of green power switch in.
The snowflake icon on the control panel will light up blue, indicating the unit is
chilling water. Once water in the cold tank is properly chilled, the blue light will turn
off automatically.
Activate Nightlight
Push top side of blue power switch in to turn light on. Push bottom side in to turn
light off.
Provide Electricity to Brewer
1.
Plug brewer cord into a ground fault interrupting receptacle.
2.
Activate ON switch.
Activate Water Pump to Brewer
Notices:
Do not proceed until the dispenser chilling tank is full. This can take up to twenty
minutes from the time you provide power to the dispenser.
Dispenser will not pump water to brewer until the switch is activated.
Do not activate the switch until the water line is properly installed.
To activate, push top side of red power switch in to start pumping water.
Once the switch is activated, the unit will begin its test cycle and start pumping water
to brewer.
