If you have questions or issues please contact 1-866-429-7566 for expert assistance.
_______________________________________________________________________________________
Please visit
www.PrimoWater.com
for more useful information, instructional videos, tips and special offers.
Page |
8
USING DISPENSER WITH Plumbable Single Serve Brewing System
Install Brewer
Notice: This dispenser has been engineered specifically for use with a Keurig®
K150P Plumbable Single Serve Brewing System. Do not attempt to operate with
any other model brewer. Consult brewer User Manual for setup and operating
instructions before attempting assembly or use.
1.
Place brewer on top of dispenser.
2.
Make sure the brewer’s power cord is led through the notch in the back of the
top panel.
3.
Remove plug dispenser spout. Insert water line into dispenser spout and hand
tighten connector on brewer.
Notice: Do NOT plug in power cords from brewer or dispenser yet.
Install Water Bottle
1.
Open dispenser door.
2.
Place probe on hanger.
3.
Place fresh bottle of water outside of cabinet.
4.
Remove entire plastic cap from top of bottle.
5.
Clean outside of new bottle with a cloth.
6.
Place probe into bottle.
7.
Slide probe down until it clicks in place.
8.
Slide bottle into cabinet and close door.
Provide Electricity to Dispenser
1.
Plug dispenser cord into a ground fault interrupting receptacle.
2.
At this time the dispenser will begin to move water from bottle to chilling tank. It
will take up to 20 minutes to fill the tank for the first time. During this period the
pump may run continuously. This is normal.