Maintenance and Troubleshooting 53
• With the Publisher turned on, press the
Cartridge Button
• While holding the Cartridge Button, press the
Power Button until the robotics start to move.
• Release both buttons
• To stop the test, wait until the disc has moved to the
Output Bin and press the Power Button.
C. CLEANING THE INK CARTRIDGES
It may be necessary to clean the ink cartridge nozzles if you
notice reduced print quality, or if you suspect an cartridge
nozzle has become slightly dried out or clogged. If you are
having print quality problems, follow the steps below:
1. Remove the print cartridges.
2. Moisten a lint-free cloth with water.
3. Hold the cloth against the
nozzles for three seconds.
This will “wick” some
additional ink onto the
damp cloth.
4. Wipe in the direction shown.
5. Repeat the process.
D. TRANSPORTING THE PUBLISHER
To prevent damage to the Publishers robotic arm during
shipment, it is important to properly secure it. To prepare for
transport, remove the ink cartridges and disc holders, close the
front cover and then do the following:
1. The cover must be closed for this operation to complete.
However, in order to access the buttons you must open the
cover. To get around this problem simulate closing the
cover by activating the cover lock sensor. You may do this
by putting an object such as a folded piece of paper in the
slot where the lock would normally be located.
510930.qxd 11/25/2009 2:20 PM Page 53
TOC
INDEX
