Creating Discs 39
Ink Saturation
This option controls the ink saturation of the printed image.
When printing onto the printer manufacturer's TuffCoat CD
media, this option can be left at its default setting of 50%.
When printing onto other brands of printable CD media, you
may need to adjust this control in order to optimize the ink
saturation for the printable surface of your specific CD media.
Click on the up and down arrows to change the ink saturation
setting. Lower numbers reduce the overall ink saturation,
while higher numbers increase it. Please note that higher ink
saturation results in higher ink usage. This will reduce the
amount of discs produced per cartridge.
Inner Diameter
This value changes the size of the non-printed center. Larger
numbers cause the non-printed center to be larger and smaller
numbers make the non-printed center smaller. This number is
incremented by 0.1mm so a change of 10 for inner diameter
changes the diameter by 1mm. For Primera TuffCoat TM media
use 230 for the inner diameter.
Centering Test Print
NOTE:
Your printer comes from the factory pre-calibrated to print the image
in the center of the CD. You can use this adjustment if you need to
fine-tune this location.
If you ever wish to verify your factory-calibrated Vertical and
Horizontal calibration settings, you can run a simple
calibration procedure to assure that your images will be
centered when printed on a CD. To do this, refer to the
following steps:
1. Verify that a disc and a color ink cartridge are installed in
the Publisher. It is important to use the same disc you
normally use for your publishing because different brands
of discs may vary slightly in size. Also, verify that the
Publisher is powered
ON
and that it is connected to your
computer.
2. Click on the
Centering Properties Test Print
button. The
printer will begin printing the calibration test print.
510930.qxd 11/25/2009 2:18 PM Page 39
TOC
INDEX
