11
Seat Installation
It may be necessary to install the seat either prior to initial
operation or after transporting your Go-Chair. The seat is
attached to the power base by a height-adjustable seat
post.
WARNING! Do not pick up the seat frame
by the armrests. They are free to pivot,
and you may lose control of the seat if
they do so.
To install the seat:
1. Adjust the seat height if necessary. See “Comfort
Adjustments.”
2. Set the seat onto the seat post.
See fi gure 5.
3. Install under-seat storage. See “Comfort Adjustments.”
4. Install the controller into the armrest, and tighten the
setscrew under the armrest.
5. Route the controller harness to the rear of the power
base.
6. Plug the controller harness connector into the power
base.
7. Secure the controller harness to the armrest with
wire ties.
See fi gure 5.
MANDATORY! Prevent controller harness
damage! Avoid routing the controller
harness on the outside of the armrest
pad. Route the harness under the armrest
or toward the inside of the armrest pad.
Use correct tie-down points for the
controller harness to prevent the harness
from getting caught in the drive tires,
pinched in the seat frame, or damaged
when passing through doorways.
Disassembly
The Go-Chair disassembles into fi ve components: the
seat, the under-seat storage bin, the battery box, the
rear section of the power base, and the front section of
the power base.
See fi gure 6.
To disassemble the Go-Chair:
1. Turn off the power to the controller.
2. Place the Go-Chair in drive mode, if not in drive mode
already. See “Your Go-Chair.”
3. Unplug the controller from power base.
4.
Remove under-seat storage. See “Comfort
Adjustments.”
5. Remove the seat by lifting it straight up and off of the
Go-Chair. If you encounter resistance when removing
the seat, disengage the seat release lever and swivel
the seat back and forth while lifting up on the seat.
6. Grasp the battery box handle and lift up to disengage
the box from the power base, then tilt the box foward
slightly and pull it away from the power base.
7. Disconnect two halves using the frame release lever.
1
2
Figure 5. Seat Installation
1
3
4
5
2
6
Figure 6. Go-Chair Components
Identifi cation Key
Identifi cation Key
1. Seat
2. Seat Release Lever
3. Under Seat Storage
4. Front Section
5. Rear Section
6. Battery Box
1. Wire Tie
2. Controller Connector
