8
1
3
4
5
6
7
2
8
Figure 2. The Go-Chair Power Base
Electrical Components
The electrical components are located on the power base. The main circuit breaker is located on the front
of the battery box. The controller connector is located on the back of the power base.
See fi gure 2.
Controller Connector:
This is where the controller connects to the power base. Each controller uses a
different type of cable. Regardless of which type of controller is used, the cable must be secured to the
assembly and not allowed to drag on the fl oor.
Battery Box Charger Port:
This enables you to charge the batteries when the battery box is removed
from the power base. See “Batteries and Charging.”
Main Circuit Breaker:
The main circuit breaker is a safety feature built into your Go-Chair. When the
batteries and the motors are heavily strained (e.g., from excessive loads), the main circuit breaker trips
to prevent damage to the motors and the electronics. If the circuit trips, allow your Go-Chair to “rest” for
approximately one minute. Next, push in the circuit breaker button, turn on the controller, and continue
normal operation. If the main circuit breaker continues to trip repeatedly, contact an authorized Pride
Provider.
Identifi cation Key
1. Manual Freewheel Levers
2. Seat
post
3. Battery
Box
4. Battery Charger Port Location
5. Circuit
Breaker
6. Front
Section
7. Rear
Section
8. Controller Connector Location
