18
WARNING! If your battery charger has not been tested and approved for
outdoor use, then do not expose it to adverse or extreme weather conditions.
If the battery charger is exposed to adverse or extreme weather conditions,
then it must be allowed to adjust to the difference in environmental conditions
before use indoors. Refer to the manual supplied with the battery charger for
more information.
NOTE: The Go-Chair batteries can be charged
with the battery box either installed on or
removed from the power base.
To charge the batteries using the off-board
charger:
1. Position the front of your travel chair next to a
standard electrical outlet.
2. Be certain the controller power is turned off and
the freewheel levers are in the engaged position.
See “Your Go-Chair.”
3. Plug the off-board charger into the off-board
charger/programming socket of the controller.
4. Plug the off-board charger into the electrical
outlet.
WARNING! The LED lights on the
charger indicate different charger
conditions at various times: charger
power on, charging in progress,
and charging complete. If the LED
does not indicate that charging is
completed within 24 hours, unplug the
charger from the outlet and contact
your authorized Pride Provider. Refer
to the manual supplied with the
charger for a complete explanation
of these indicators.
Figure 14. Battery Charging
5. When the batteries are fully charged, unplug the off-board charger from the electrical outlet and then
from the controller.
To charge the batteries with the battery box removed from the power base:
1. Remove the battery box from the power base.
2. Position the battery box next to a standard electrical outlet.
3. Plug the off-board charger into the battery box charger port.
See fi gure 14.
4. Plug the off-board charger into the electrical outlet.
NOTE: If this is a Pride off-board charger, then there are two lights in it. The red light indicates that
power to the off-board charger is on. The green light indicates that the batteries are fully charged.
If it is not a Pride off-board charger, then follow the instructions supplied by the manufacturer.
5. When the batteries are fully charged, unplug the off-board charger from the wall outlet and then from
the battery box.
6. Reinstall the battery box to the power base.
