9
Manual Freewheel Levers
For your convenience, your Go-Chair has a manual freewheel lever on each motor. Manual freewheel
levers enable you to disable the drive system in order to maneuver the chair manually.
WARNING! Do not use the travel chair while the drive motors are disengaged!
Do not disengage the drive motors when the travel chair is on an incline or
decline, as the unit could roll on its own! Only engage the freewheel mode
when on a level surface.
WARNING! It is important to remember that when your Go-Chair is in freewheel
mode, the braking system is disengaged.
NOTE: Pride strongly recommends you do not charge your batteries while in freewheel mode.
NOTE: You must turn off the power before disabling the drive systems; otherwise, you may get an
error code on the controller. To clear this code, turn off the controller and place the Go-Chair in
drive mode. Then turn on the controller. The error message should be cleared. If not, contact an
authorized Pride Provider.
To engage or disengage the drive system:
1. Locate the levers on the rear section of the power base.
See fi gure 3.
2. Push the two levers toward the front of the power chair to engage the drive motors (drive mode).
3. Pull the two levers toward the rear of the power chair to disengage the drive motors (freewheel mode).
If a lever is diffi cult to move in either direction, rock your travel chair back and forth slightly. The lever
should then move to the desired position.
WARNING! Do not use the freewheel lever handles as tie-down points to secure this
product.
Anti-Tip Wheels
The anti-tip wheels are an integral and important safety feature of your Go-Chair. They are bolted to the
frame at the rear of the chair.
See fi gure 3.
PROHIBITED! Do not remove the anti-tip wheels or modify your travel chair in any way
that is not authorized by Pride.
Figure 3. Back of Power Base
Freewheel Mode (Drive Disengaged)
Drive Mode (Drive Engaged)
1
2
1. Manual Freewheel Levers
2. Anti-tip Wheels
Identifi cation Key
