Page
9
of
14
5.
Unscrew the two clamps on the lid of the tank.
6.
Lift and remove the lid.
7.
Carefully pour the solution into the tank. Do NOT exceed the capacity of the tank (max 2.5gal of liquid).
Use a funnel as needed for pouring.
8.
Return the lid to the tank and fasten the two clamps evenly and securely. Gradually alternate clamps
during the tightening process to ensure a complete and even seal.
9.
Close/lower the top access panel.
4.3 Operating Procedure:
1.
Make sure all Before Use Checks and the Filling the Tank Procedures have been completed and the
environment is safe to operate in.
a.
VERIFY THE TANK DRAIN VALVE IS COMPLETELY CLOSED (HANDLE IS TO BE PERPENDICULAR
TO THE PIPE), ALLOWING THE SOLUTION TO FLOW TO THE SPRAY GUN.
2.
Plug the unit into a 120VAC GFI protected outlet, and the GFI test light will illuminate.
3.
At the HydroCleaner, locate the Power Off/On switch and turn to the On position.
4.
The switch will illuminate, an internal fan will start (on skinned units only), and the pump will engage to
pressurize the equipment as needed.
5.
Once the equipment is pressurized and the pump turns off, the unit is ready to begin spraying.
a.
NOTE: The spray gun will release the contents of the tank into the air; be sure to appropriately
dispense the tank contents following all SDS and safety regulations for the solution dispensing
procedures.
6.
Squeeze and hold the trigger on the spray gun to dispense the solution.
a.
NOTE: During the spraying process, the pump may turn on/off as needed to maintain required
pressure. This is normal.
7.
Release the trigger on the spray gun to stop dispensing the solution.
8.
If the desired spray stream is not emitted, the pump, tank, or spray gun may need adjusted
accordingly.
a.
See the Spray Adjustments section for detailed instructions.
9.
When finished spraying, release the trigger on the spray gun and turn the Power Off/On switch to Off.
10.
Follow Care Instructions (section 5) after every use.
4.4 Spray Adjustment:
1.
Make sure all Before Use Checks, Filling the Tank, and Operating Procedures have been completed and
the environment is safe to operate in before adjusting the spray gun.
2.
Make sure the HydroCleaner is plugged in and the Power Off/On switch is in the On position.
3.
The air cap on the front of the sprayer gun may be rotated to adjust the direction of the spray. Do NOT
exceed 360° and loosen the cap.
4.
The liquid flow of the sprayer may be adjusted by rotating the knob clockwise to restrict flow and
counterclockwise to increase flow (see Figure 4.4.1). Adjust as necessary to achieve desired spray.
