PREMIER TECH Solido SMART, Руководство по эксплуатации, включая журнал операций, инструкция по установке, вводу в эксплуатацию и техническому обслуживанию

Страница: 37 / 64

7. Installation and start-up
Premier Tech 37 / 64 Solido SMART
DOKK5110E 15.04.2020
7.3.4 Connecting the air inlet supports
•
Push the supply air hose ( 8 ) through the seal on the shaft.
•
Set the air inlet support in a suitable position next to the treatment tank at a max.half of
total length into the ground (at least 40 cm above ground; if necessary, the hose can be
extended up to a total length of 10 m).
Note:
When laying the hose, ensure there is a gradient in the direction of the air inlet
support (lower part of the air inlet support = condensate trap). When doing so,
ensure that the hose is pushed into the shaft up to the red marking so that a
sufficiently long hose piece that can comfortably be guided up to the top ground
surface remains in the shaft. Set the aeration cap included in the scope of
delivery onto the air inlet support.
7.3.5 Laying the control cable
•
Place the technology capsule next to the
ready and installed treatment tank with
shaft, at the same level.
•
Pull the control cable through the control
cable (
20 ) conduit connected to the seal
on-site up to the control unit installation
position. Whilst doing so, protect the plug
from moist or dirt.
•
Hang any excess cable either next to the
control unit or in the cable holder in the
shaft (removing the plug or shortening the
cable voids your warranty claim).
•
Seal the conduit so that no unpleasant smells can escape. Do not wall it in, etc., because
the control cable may need to be pulled out in the case of damage.
8
20
air inlet support
air vent
gradient
condensate trap
min.40 cm