VPM
Installation Instructions
Visit the Premier Mounts website at www.mounts.com
Page 7
The universal spacer may be stacked six (1) high. It will
fit M4, M5, M6 and M8 screws sizes.
The universal spacers must be placed between the
attachment head/adapter plate and the
flat-panel.
The universal spacers must be stacked in the direction
shown to the right.
Proceed to the
“Installing the Adapter Plate
(Optional)”
section.
Universal Spacer Installation (Optional)
If your flat-panel has uneven mounting points,
or recessed mounting points, please use the
provided universal spacers.
Selecting the Mounting Hardware
1) Insert a small straw or toothpick into the threaded
inserts found on the back of the flat-panel.
2) Use a pencil to mark the depth of the threaded insert
on the small straw or toothpick.
3) Mark the straw or toothpick 1/8” above the depth of
the threaded insert, as shown in Figure 1.
4) Insert the small straw or toothpick into the remaining
threaded inserts to compare and verify their depth
using the straw or toothpick’s 1/8” allowance mark.
5) Locate the correct diameter screw for the threaded
insert.
If the screw you selected is longer than the 1/8”
allowance mark on the small straw or toothpick,
as shown in Figure 2 and Figure 3, do not use this
screw. The screw length must not bypass the mark.
6) Test each size of the screws provided.
The correct screws should thread easily into the
mounting point and not pull out when tension is
applied.
Proceed to the
“Universal Spacer Installation
(Optional)”
section.
Small Straw
or Toothpick
Small Straw
or Toothpick
Small Straw or Toothpick
Marking the 1/8”
Allowance
Depth Plus 1/8”
Allowance
Mark
Depth Plus 1/8”
Allowance
Mark
