VPM
Installation Instructions
Visit the Premier Mounts website at www.mounts.com
Page 11
Attaching the VPM Mount to a Pole
Re-insert the M8 x 40mm hex screws or insert M8 x 40mm
security screws into the two halves of the VPM to clasp
them around the pole at the desired position
(Figure 1).
At least two qualified people are needed to attach the
flat-panel and VPM to a pole.
If you are using a 2” pipe, replace the M8 x 40mm hex
screws with M8 x 60mm security screws (Figure 2).
Proceed to the
“Adjusting the VPM Mount Tension”
section.
Drawings not to scale.
Mounting hardware not shown.
Figure 1
Figure 2
2” Pipe
M8 x 60mm
Hex Screw
Caution:
Front plate of VPM
Back plate of VPM
M8 Screws
Tighten both screws
simultaneously
Note: Do Not overtighten the M8 Screws
-200
