PTFM3765
Installation Instructions
Visit the Premier Mounts website at http://www.mounts.com
Page
15
Align the wall plate over the steel stud anchor sleeves.
Insert a steel stud anchor screw and a
5
/
16
″
washer into
each steel stud anchor sleeve.
Use a Phillips screwdriver and tighten each steel stud
anchor screw until it is just snug.
Do not overtighten the steel stud anchor screws.
Do not use a power drill to tighten the steel stud
anchor screws.
Proceed to the
“Mounting Hardware Installation”
section.
Step 5
Selecting the Mounting Hardware
Insert the Thread Depth Indicator into the thread
inserts found on the back of your
fl
at panel.
Use a pencil to mark the depth of the thread insert
on the Thread Depth Indicator, as shown in Figure 1.
Insert the Thread Depth Indicator into the remaining
thread inserts to compare and verify their depth.
Locate the correct diameter screw for the thread
insert.
If the screw you selected is longer than the mark
on the Thread Depth Indicator, as shown in Figure
2 and Figure 3, do not use this screw. The screw
length must not bypass the mark.
Test each size of the screws provided.
The correct screws should thread easily into the
mount point and not pull out when tension is
applied.
Proceed to the
“Universal Washer Installation”
section.
Mounting Hardware Installation
X
X
Installing the Wall Plate (cont’d)