PP-FCTA-QL
1) Pre-set four (4) M5 x 16mm combo screws on the
ceiling plate assembly (two on each end of the plate).
2) Remove any of the 24˝ x 24˝ or 24˝ x 48˝ tiles that are
surrounding the marked tile.
3) Measure 3˝ from the edge of the t-bar frame to the
inside of the tile (do this for all four edges of the
ceiling tile).
4) The mounting hole should be located in the
center-most location of the ceiling tile.
5) Once the mounting hole has been cut, place the
ceiling plate assembly on the t-bar rails.
M5 x 16mm Screws
Upper Adapter Plate
Ceiling Plate Assembly
Mounting Hole
T-Bar Frame
Ceiling Tile
3˝
3˝
3˝
3˝
Mounting the PP-FCTA-QL
Proceed to ″Securing the Ceiling Plate″ section.
1/4”-20 camera screw holes
Page 6
