CTM-MS2
Page 6
Visit the Premier Mounts website at http://www.mounts.com
Installation Instructions
Installing the Mounting Brackets
Selecting the Mounting Hardware
1)
Insert a small straw or toothpick into the threaded inserts found on the
back of the flat panel.
2)
Use a pencil to mark the depth of the threaded insert on the small straw or
toothpick.
3)
Mark the straw or toothpick 1/8” above the depth of the threaded insert, as
shown in Figure 1.
4)
Insert the small straw or toothpick into the remaining threaded inserts
to compare and verify their depth using the straw or toothpick’s 1/8”
allowance mark.
5)
Locate the correct diameter screw for the threaded insert.
If the screw you selected is longer than the 1/8” allowance mark on the
small straw or toothpick, as shown in Figure 2 and Figure 3, do not use
this screw. The screw length must not bypass the mark.
6) Test each size of the screws provided.
The correct screws should thread easily into the mounting point and not
pull out when tension is applied.
Proceed to the “Griplate™ Installation” section.
Small Straw or Toothpick
Small Straw
or Toothpick
Small Straw
or Toothpick
Marking the 1/8”
Allowance
Depth Plus 1/8” Allowance
Mark
Depth Plus 1/8” Allowance
Mark
