CTM-MS2
Installation Instructions
Visit the Premier Mounts website at http://www.mounts.com
Page 5
Installing the Wall Plate (cont’d)
1)
Place the wall plate against the wall and align it with the pilot hole.
2)
Insert one (1)
5
/
16
˝ x 3˝ lag bolt and one (1)
5
/
16
˝ washer into the upper right
pilot hole.
3)
Use a socket wrench and a ½˝ socket to tighten the lag bolt.
Do not overtighten the lag bolt.
Step 4
Step 5
Step 6
1)
Level the wall plate.
2)
Use a pencil to mark the remaining three (3) mounting locations along the
center of each wall stud.
Two people are recommended for this step; one person to level the wall
plate and another person to drill the pilot holes.
Drill a “pilot hole” in the center of each of the marks with a power drill and a ¼″
drill bit.
Only use ¼″ drill bit when drilling the pilot holes.
Step 7
1)
Insert one (1)
5
/
16
″ x 3″ lag bolt and one (1)
5
/
16
″ washer into each pilot hole
2)
Tighten all lag bolts using a socket wrench and ½″ socket.
Do not overtighten the lag bolts when attaching the mount to the wall.
Improper installation may result in personal injury or property damage.
Proceed to the “Installing the Mounting Bracket” on page 8.
