CTM-MS2
Page 10
Visit the Premier Mounts website at http://www.mounts.com
Installation Instructions
Locking Safety Screw Installation
The locking safety screws keep the flat panel from being accidently
dislodged from the CTM-MS2.
1)
Thread an M6 x 30mm locking safety screw at the bottom of one of the
mounting brackets.
2)
Use a Phillips head screwdriver to tighten the locking safety screw.
3)
Repeat steps 1 and 2 for the other locking safety screw.
Do not overtighten the locking safety screws.
Tilt Adjustment
Adjusting the Flat Panel Friction Tilt Angle
1)
Place one hand at the center top edge of the flat panel.
2)
Place the other hand on the center bottom edge of the flat panel.
3)
Using the upper hand, gently pull the top of the flat panel towards you
while the lower hand gently pushes the bottom of the flat panel away from
you.
Adjusting the Flat Panel to the Original Position
1)
Place one hand at the center top edge of the flat panel.
2)
Place the other hand on the center bottom edge of the flat panel.
3)
Using the upper hand, gently push the top of the flat panel towards the wall
while the lower hand gently pulls the bottom of the flat panel away from the
wall.
M6 x 30mm
Locking Safety Screw
(1 per Bracket)
Proceed to the “Installing the Mounting Bracket” below.
