Plug the cables into the chin circuit board
Use the following procedure to replace the current console chin with the device
charging chin included in your hardware kit.
The console ships with either a blank chin or a USB charging chin. The cable
routing differs depending on the type of chin. If you have a device charging chin,
skip to the Route the audio cable section.
IMPORTANT
Do not stretch, crimp, or damage the cable. Cables damaged by improper
installation will not be covered by the Limited Warranty.
To rewire a blank chin:
1.
Remove existing chin from the console.
2.
Slide heart rate board from console and move to side to allow more space.
3.
Thread the ground wire through the cable slot at the base of the console.
4.
Attach the ground wire using a tooth lock screw.
5.
Feed the USB charging cable from the top of the console.
A Thread it behind the metrics board.
B Feed through the cable retention slot.
C Feed down through the cable slot at the base of the console.
A
B
C
A
B
C
1
5