Rewire the Recumbent Bike
Remove the front and side access covers to provide sufficient space to install the
console cables.
NOTE
You need to remove only one side cover to thread the cables.
To thread the new cables through the equipment:
Step
Procedure
Remove the top cover.
Remove the back cover.
Remove the side cover.
Remove blank jack panel from the front base of the bike.
Feed the cables down the mast.
The cables need to be threaded around the bolts that hold the center
mast in place.
Feed the cables through the square opening in the jack panel using
the communication cable’s wire retaining feature, then slide the jack
panel back into its mounting.
Important The cables must be secured in the cable retainers along the
frame (with the communications cable) and then exit the square hole in
the jack panel. You may need to slide out the jack panel to remove the
CAT5 coupler and feed the cables through the hole. If so, return the jack
panel to its previous position when you are finished.
N/A
Reattach the bike covers in reverse order as removed in first three
steps.
1
0