Auto Stop Troubleshooting
This procedure will provide troubleshooting steps for the Auto Stop feature
Related Error Codes
Auto Stop error codes: 60, 61.
Refer to the
Error Code Troubleshooting Guide
for error code description and troubleshooting
information.
Procedure:
1. If the Console message is "Temporarily Out of Order" on the P80 console or "Please
use another Treadmill" on the P10, P20, or P30 console go
Run Hardware Validation
Tests below.
2. Check the treadmill to ensure the Auto Stop hardware is installed.
l
If the Auto Stop hardware is not installed, contact Precor customer support to see
if your treadmill is compatible for the Auto Stop or arrange the installation of the
Auto Stop hardware.
3. Verify that the Auto Stop cable is plugged into the correct port in the console. The con-
nector for the Auto Stop is the same number of pins as the connector for the heart rate
grips, and you need to make sure that they were not reversed.
a. If the cables were reversed, swap the connectors and re-test.
b. If the cables were correctly connected, continue
4. If the Auto Stop hardware is installed, access the club settings and check if the Auto
Stop feature is enabled. If it is not enabled, enable the feature, see .
Run Hardware Validation Tests
5. Access the service access software Hardware Validation Tests (see and select the
Auto Stop test. If the feature is enabled the P80 Auto Stop sensor test will count the
number of times the magnet crosses the sensor. The P10, P20, or P30 consoles will dis-
play USER DETECTED if motion is detected from the running deck or NO USER
DETECTED if no motion is detected from the running deck. If the unit passes this test or
a USER DETECTED message is displayed and the Auto Stop feature does not func-
tion contact Precor Customer Support. If the Auto Stop did not pass the test continue
troubleshooting.
Contact Precor Customer Support at [email protected] or 800.786.8404 with
any questions.
Page 100
7 Troubleshooting
System Troubleshooting Procedures